Bolts, clips, pins
-
NZ$8.80This specific nut compresses when fitted and needs to be replaced once removed. A reused nut can cause your scooter variator or clutch to pop off, usually when you are at top speed - not good! M12 thread to suit Piaggio, Vespa Leader engines etc. Learn More -
NZ$0.29M4 thread, 10mm long screw. Suitable for holding on the brake reservoir caps of most scooters. Bright zinc coating for anti-corrosion. Philips head. Learn More -
NZ$1.49Allen bolt / machine screw to suit many transmission covers, kick start levers, handle bar clamps etc. 6mm diameter metric thread, 25mm long thread. Learn More -
NZ$1.49Allen bolt / machine screw to suit many transmission covers, kick start levers, handle bar clamps etc. 6mm diameter metric thread, 30mm long thread. Learn More
-
NZ$0.40Split pin 2mm diameter, 22mm long. Suitable for scooter / motorcycle use. Do not reuse these split pins, they are intentionally made to be soft, therefore they are likely to break if bent more than once. Learn More -
NZ$3.50High quality stainless steel, band type construction, by Tridon (Australia). The image shows a range of sizes, this is for one only. This is a worm drive hose clamp, suitable for fuel, air and low pressure oil lines in all weather applications. The screw has both a slot for flat screwdrivers and a hex head. Learn More -
NZ$3.50High quality stainless steel, band type construction, by Tridon (Australia). The image shows a range of sizes, this is for one only. This is a worm drive hose clamp, suitable for fuel, air and low pressure oil lines in all weather applications. The screw has both a slot for flat screwdrivers and a hex head. Learn More
-
NZ$3.50High quality stainless steel, band type construction, by Tridon (Australia). The image shows a range of sizes, this is for one only. This is a worm drive hose clamp, suitable for fuel, air and low pressure oil lines in all weather applications. The screw has both a slot for flat screwdrivers and a hex head. Learn More
-
NZ$3.50High quality stainless steel, band type construction, by Tridon (Australia). The image shows a range of sizes, this is for one only. This is a worm drive hose clamp, suitable for fuel, air and low pressure oil lines in all weather applications. The screw has both a slot for flat screwdrivers and a hex head. Learn More
-
NZ$13.98Worn bushings can cause poor handling and control, increase tyre wear and fuel consumption and can be especially dangerous at speed. This suits the engine mounts (engine case side) of Suzuki TR50 Street Magic, Honda Dio AF18-AF35, Honda Giorno/Tact AF24 Dimensions 28mm OD x 10mm ID x 19mm wide. Genuine Honda or Suzuki items will be supplied Learn More